start
|
end
Hot Sale 1/3″ CCD 800TVL Color Home Door Hole Eye Peephole Pinhole Viewer Security mini CCTV Camera for 25-30mm Thickness Door
Sony CCD camera cat
Product Size:
Lens diameter 32MM
Intermediate thin section 25MM
The total length 30MM – 85MM adjustable
At the bottom of the thickest part of the 36MM
Simple installation instructions:
Fancy chart, Accessories sequentially spin down, and then the former cat burglar doors down, expand the appropriate space (big generous about 25MM) and the product penetration from the outside, and finally the other accessories can be fitted
Image Sensor 1/3 Inch SONY CCD image sensor
Horizontal resolution 800 TV Lines,
No amount of infrared light (without IR)
Scanning frequency PAL: 15.625 kHz / 50 KHz
Scanning System 2: 1lnterlace, 2: 1 interlace
Minimum illumination 0.5 Lux
Internal Synchronization Internal / DC12V
Signal / noise ratio greater than 48dB Better than
Auto Auto Electronic Shutter 1/50 ~ 1 / 100,000 sec.
Video Output 1 Vp-p, 75 composite signal
Power supply 12V DC ( 10%)
1.7mm lens configuration
Power Consumption 800mA / DC12V
Standard accessories:
1. Camera (wide angle 170 degrees) a
Tips: This camera without power and other accessories.
Trouble and Solution:
1. No Picture after providing power
May be the power supply voltage abnormity, please check the power supply voltage and pole whether exactitude.
Please check all the conecting cable and monitors whether be connected correctly or not.
2. The picture level direction have flowing interference ripples
May be caused by the power supply AC ripples, it need filter the wave of the power supply.
Check the monitor and peripheral equipments used.
3. The picture background color changes continuously
The fluorescent lamp\’s electromagnetic field cause color roll. This is proper phenomenon of the cameras.
Reduce the fluorescent lamp numbers or increase the distance between the camera and the fluorescent lamps can
improve it.
Use Power supply external sync. Camera can solve it.
4.The picture smear too mass
The power supply\’s voltage unstable
Connecting cables not connect correctly or have high impedance.
Trouble and Solution:
PS: PAL format is for Euro Courty, NTSC
format is for USA, Canada,
if you don\’t know which one you need, please feel free to contact us.
1. No Picture after providing power
May be the power supply voltage abnormity, please check the power supply voltage and pole whether exactitude.
Please check all the conecting cable and monitors whether be connected correctly or not.
2. The picture level direction have flowing interference ripples
May be caused by the power supply AC ripples, it need filter the wave of the power supply.
Check the monitor and peripheral equipments used.
3. The picture background color changes continuously
The fluorescent lamp\’s electromagnetic field cause color roll. This is proper phenomenon of the cameras.
Reduce the fluorescent lamp numbers or increase the distance between the camera and the fluorescent lamps can
improve it.
Use Power supply external sync. Camera can solve it.
4.The picture smear too mass
The power supply\’s voltage unstable
Connecting cables not connect correctly or have high impedance.
Reviews
There are no reviews yet.